Canon Arizona 6100 XTHF Mark II Series User Manual

Print job This command can do the following actions depending on context:• Activates a selected inactive job by moving it to the active list.• Un-holds a held job.• Un-holds an job that had an error currently.Hold job The command can do following actions depending on context:• Puts an active job on hold.• Waits until the printer finishes a currently printing copy and puts the jobon hold.Cancel job The command can do following actions depending on context:• Deactivates a selected active job by moving it to the inactive list. Notethat Special Prints will not move to the inactive list.• Cancels a currently printing job and moves it to the inactive list. Notethat the first click cancels the print, but the carriage will continue to ap-ply curing passes so that the ink cures properly. A second click termi-nates the print job immediately.Delete job Deletes a job from the printer. However, you cannot delete a job that is cur-rently printing.Flatbed icon Process flatbed jobs toggle command - Allows printer to process flatbedjobs. This must be selected to enable flatbed printing when the printer isbooted or after re-setting the printer due to an error.Flatbed Settings A dialog window automatically appears when confirmation is required. If itis closed before you select Confirm, it can be reopened by clicking on thisbutton.Media ParametersEnter or confirm the thickness of the media. The printer will automaticallyadjust the carriage height to media thickness and also the print gap. Mediathickness confirmation is required only for the first copy of a print job, un-less it is changed during printing. If the media thickness value is changedwhile printing, confirmation is requested before printing the next copy.Lamp Power ControlAllows the operator to control the power output of each UV lamp inde-pendently. To extend lamp life, use the lowest setting that provides ade-quate curing for a particular media.Leading and Trailing Edge are relative to the direction of carriage travel. Toenable or disable this setting, seeUser Interface Settings on page 75.When enabled, this feature automatically matches the power of the trailingUV lamp, when power of the leading UV lamp changes. It is still possible toadjust the power of the trailing UV lamp individually, when this setting isnot enabled. 4Print Job Control Module64 Chapter 3 - How to Navigate the User Interface