Canon Arizona 6100 XTHF Mark II Series User Manual

When an image is out of bounds in the actual table area, that area in the table preview is markedin red.When an image is out of bounds in the bleed region, that area of the table preview is marked inyellow.8) Inactive Print Job ListInactive job list consists of a table and job count summary on top. A job count summary displaysthe total number of inactive jobs. The list can be sorted by clicking on the appropriate columnheader. The icons in the first column reflect the job type and status and can be use to sort the list.The size column is sorted by image area. Date column is sorted by a compound value of date andtime. The inactive job list has the following features:• The operator can drag and drop jobs to move them between the active and inactive job lists.• Jobs deleted from the inactive list are deleted from the hard drive.• The operator can automatically set the status of a job to Hold when the job is put in this queue.This can be set separately for flatbed and roll media jobs.9) Job information and parameters panelThe job information area displays only relevant job parameters of the current print job. Some ofthe parameters may be modified.Offsets To change parameter values, click on the field and this brings up an onscreenkeyboard so you can click on the numbers required. It can also be changedwith the mouse wheel when the mouse cursor is positioned over the field. Ro-tate the mouse wheel up or down increments or decrements offset at the rateof one unit per notch. Hold the right mouse button and rotate the wheel incre-ments or decrements at the rate of 10 units per notch. You can also use Pre-view to drag an image to the desired position.Position on media - No:• Horizontal distance• Vertical distancePosition on media - Yes:• Media horizontal distance - Enter the horizontal distance of the media• Media vertical distance - Enter the vertical distance of the media• Media width - Enter the media width (default = Image width + Media hori-zontal distance)• Media height - Enter the media height (default = Image height + Media ver-tical distance)• Image alignment on media - The offset values for the image on the media• Horizontal distance• Vertical distancePrint Parame‐tersDisplays information about the print job that is currently selected:• Print Mode - Print modes are selected in THRIVE. See "Print Modes Availa-ble" below for details of each mode.• Direction - Bidirectional and Forward or Reverse unidirectional printing.• Overprints - If the Overprint count is set to greater than 0 (zero), the printerwill re-print the image again, that many times, on the same piece of media. 4Print Job Control ModuleChapter 3 - How to Navigate the User Interface 67