122 Problems and Solutions Without MessagesProblems and Solutions WithoutMessagesFirst page prints correctly in the font and format specified in thesoftware application, but midway through the job the font andformat changes?The printer has initiated a job timeout. When a job timeout occurs, thedownloaded fonts and formatting commands specified by the softwareapplication are lost, so printing after the job timeout is completed withoutthe downloaded font and format.If the print job came over the parallel port, increase the I/O TIMEOUTsetting or disable it on the PARALLEL1 MENU or PARALLEL2 MENU(see pages 71 to 73).Printer not using the font you want?You have specified a font that is not available.Print a PCL or PS Font List and see if the font you specified is available(see page 90 or 101).Indicators off and display blank?Power switch is not turned on.Check the power switch to ensure the printer is turned on.-or-Power cord is not attached.Check the power cord and be sure it is connected at both ends.-or-No power at the power source.Check the main power source. Consult an electrician or the local powercompany. If you are using a power strip, ensure power lead is connectedat the source and turned on.One edge of the document is cut off?You are attempting to print something outside the printable area of thepage.Use your software application to adjust the margins of the page. Checkand ensure that your software application is not trying to print graphicsor text outside the printable area.Font changesFont not usedIndicatorsMargin