593The Standard Printing Environment SettingsFNTSRC (font source) allows you to set the default for font selection. After you printa font list, you will see the fonts listed as internal fonts or soft fonts (see page 90).INTERNAL Selects internal (resident) fonts.SOFT Selects permanent soft fonts. Permanent soft fonts are downloadedto the printer’s memory by software applications. These fonts arenot erased from memory once a job is completed. They remain inRAM until the printer is turned off.FLASH Selects fonts that have been downloaded and stored in the optionalCanon Flash ROM Module FR-32.FONTNUM (font number) allows you to set the font default by its number. The printerassigns a font number to every typeface. Print a PCL Font List to see the numbersassigned to the fonts. The font number (Font #) is the first column in the list (see page 91).You must select FNTSRC (font source) before FONTNUM will appear.If the currently selected font does not support the orientation or symbol setyou’ve selected, the printer control panel font selection returns to the 000factory default setting.0 Courier is selected unless you change the setting.1 to 999 To increase the number, press Value. You can quickly scrollthrough the numbers in increments of 10 by holding down Value.To decrease the number, press Shift and Value, or press and holdShift and Value to move backward quickly in decrements of 10.The font souce is shown in the Font List by the first character on every line:I Internal (resident) fontsS Soft fontsF Flash ROM fontsPCL MENUFNTSRC=INTERNAL *PCL MENUFONTNUM=0 *
