150 Configuring System InformationViewing the ARP Table Using CLI CommandsFor information about the CLI commands that perform this function, see the IP Addressing Commandschapter in theCLI Reference Guide. The following table summarizes the equivalent CLI commands youuse.IPv6 Management FeaturesThe PowerConnect 6200 Series switch software includes several enhancements to the IPv6 managementfeature. You can assign either an IPv4 or IPv6 address to the management interface. In previous softwarereleases, the management port supported IPv6 addresses, but only when the switch received its IPv6addressing and gateway definitions through auto-configuration when connected to an IPv6 router on themanagement network. Support for host name mapping to a host with an IPv6 address is also present.To display the IPv6 Management Interface page, click System →IP Addressing →IPv6 AddressManagement in the tree view.Figure 6-30. IPv6 Address ManagementThe IPv6 Address Management page contains the following fields:• IPv6 Mode —Enables or disables IPv6 mode on the management interface.• Network Configuration Protocol — Specify whether to use DHCP for dynamic IPv6 addressassignment. If you select None, you can configure a static IPv6 address.Table 6-19. ARP Table CommandsCLI Command Descriptionshow arp switch Use to display the entries in the ARP table.
