Configuring Routing 593• VLANID - Indicates the interface associate with the VRID.• Priority — The priority value used by the VRRP router in the election for the master virtual router.• Pre-empt Mode– Enable — If the Virtual Router is a backup router it preempts the master router if it has a prioritygreater than the master virtual router's priority provided the master is not the owner of the virtualrouter IP address.– Disable — If the Virtual Router is a backup router it does not preempt the master router even if itspriority is greater.• Advertisement Interval (secs) — The time, in seconds, between the transmission of advertisementpackets by this virtual router.• Virtual IP Address — The IP Address associated with the Virtual Router.• Interface IP Address — The actual IP Address associated with the interface used by the Virtual Router.• Owner — Set to True if the Virtual IP Address and the Interface IP Address are the same, otherwise setto False. If this parameter is set to True, the Virtual Router is the owner of the Virtual IP Address, andalways wins an election for master router when it is active.• VMAC Address — The virtual MAC Address associated with the Virtual Router, composed of a 24-bitorganizationally unique identifier, the 16-bit constant identifying the VRRP address block and the 8-bit VRID. The Virtual MAC address is 00:00:5e:00:01:XX where XX is the VRID.• Auth Type — The type of authentication in use for the Virtual Router– None — Specifies that the authentication type is none.– Simple — Specifies that the authentication type is a simple text password.• State — The current state of the Virtual Router:– Initialize– Master– Backup• Status — The current status of the Virtual Router:– Inactive– Active• Secondary IP Address — A secondary VRRP address configured for the primary VRRP.Displaying Virtual Router Status Using CLI CommandsFor information about the CLI commands that perform this function, see the following chapter in theCLI Reference Guide:• Virtual Router Redundancy Protocol CommandsThe following table summarizes the equivalent CLI commands for this feature.
