442 Configuring Switching Information• Static Flag — Use this flag to determine whether the ARP packet needs validation using the DHCPsnooping database, in case the ARP ACL rules do not match. If Enabled, then the ARP Packet will bevalidated by the ARP ACL Rules only. If Disabled, then the ARP Packet needs further validation byusing the DHCP Snooping entries. The default is Disable.Configuring Dynamic ARP Inspection VLANs With CLI CommandsFor information about the CLI commands that perform this function, refer to the following chapter intheCLI Reference Guide:• Dynamic ARP Inspection CommandsThe following table summarizes the equivalent CLI commands for this feature.DAI ACL ConfigurationUse the DAI ARP ACL Configuration page to add or remove DAI ARP ACLs.To display the DAI ARP ACL Configuration page, click Switching →Dynamic ARP Inspection →ACLConfiguration in the navigation tree.Figure 7-109. Dynamic ARP Inspection ARP ACL ConfigurationThe Dynamic ARP Inspection ARP ACL Configuration page contains the following field:Table 7-60. Dynamic ARP Inspection VLAN CommandsCLI Command Descriptionip arp inspection filter Configures the ARP ACL to be used for a single VLAN or a range ofVLANs to filter invalid ARP packets.ip arp inspection vlan Enables Dynamic ARP Inspection on a single VLAN or a range ofVLANs.show ip arp inspection vlan Displays the Dynamic ARP Inspection configuration on all the VLANsin the given VLAN range.