760 Configuring IP MulticastMLD Proxy ConfigurationWhen you configure an interface in MLD proxy mode, it acts as a proxy multicast host that sends MLDmembership reports on one interface for MLD Membership reports received on all other MLD-enabledrouter interfaces.Use the MLD Proxy Interface Configuration page to enable and disable ports as MLD proxy interfaces.To display this page, click IPv6 Multicast →MLD →Proxy Interface →Interface Configuration in thenavigation tree.Figure 12-29. MLD Proxy Interface ConfigurationThe MLD Proxy Interface Configuration page contains the following fields:• Interface — Select the interface for which data is to be displayed or configured from the menu. Youmust have configured at least one router interface before configuring or displaying data for an MLDProxy interface and it should not be a MLD routing interface.• Interface Mode — Select enable or disable from the menu to set the administrative status of MLDProxy on the selected interface. The default is disable. Routing, MLD and Multicast global adminmodes should be enabled to enable MLD Proxy interface mode.• Unsolicited Report Interval — Enter the unsolicited time interval value in seconds. The UnsolicitedReport Interval is the time between repetitions of a host's initial report of membership in a group. Validvalues are from (1 to 260). The default value is 1.Click Apply Changes to send the updated configuration to the switch. Configuration changes take effectimmediately. These changes will not be retained across a power cycle unless a save is performed.Configuring MLD Proxy Global Settings Using CLI CommandsFor information about the CLI command that performs this function, see the following chapter in theCLI Reference Guide:• IPv6 Routing CommandsThe following table summarizes the equivalent CLI commands for this feature.