Configuring IP Multicast 721Multicast Admin Boundary SummaryUse the Multicast Admin Boundary Summary page to display existing administratively scopedboundaries.To display the page, click IPv4 Multicast →Multicast →Admin Boundary Summary in the tree view.Figure 12-5. Multicast Admin Boundary SummaryThe Multicast Admin Boundary Summary page displays the following fields:• Interface — The router interface to which the administratively scoped address range is applied.• Group IP — The multicast group address for the start of the range of addresses to be excluded.• Group Mask — The mask that is applied to the multicast group address. The combination of the maskand the Group IP gives the range of administratively scoped addresses for the selected interface.Displaying the Multicast Admin Boundary Summary Using CLI CommandsFor information about the CLI command that performs this function, see the following chapter in theCLI Reference Guide:• Multicast CommandsThe following table summarizes the equivalent CLI commands for this feature.Multicast Static MRoute ConfigurationUse the Multicast Static MRoute Configuration page to configure a new static entry in the Mroutetable or to modify an existing entry.Table 12-5. Multicast Admin Boundary Summary CommandCLI Command Descriptionshow ip mcast boundary Displays the system-wide multicast information.