348 Configuring Switching InformationDisplaying the STP Port Table and Configuring STP Port Settings1. Open the STP Port Settings page.2. Click Show All.The STP Port Table displays.Figure 7-40. STP Port Table3. Use the Unit drop-down menu to view the STP Port Table for other units in the stack, if they exist.4. To change the STP settings for one or more ports, select the Edit option for the port(s), configure thedesired settings, and then click Apply Changes.Configuring Spanning Tree Port Settings Using CLI CommandsFor information about the CLI commands that perform this function, see the following chapter in theCLI Reference Guide:• Spanning Tree CommandsThe following table summarizes the equivalent CLI commands for this feature.STP LAG SettingsUse the STP LAG Settings page to assign STP aggregating ports parameters.Table 7-22. Spanning Tree Port CommandsCLI Command Descriptionspanning-tree cost Configures the spanning-tree path cost for a port.spanning-tree disable Disables spanningtree on a specific port.spanning-tree guard Selects whether loop guard or root guard is enabled on an interface.spanning-tree auto-portfast Sets the port to auto portfast mode.spanning-tree portfast Enables spanning-tree portfast modespanning-tree port-priority Configures port priority.spanning-tree tcnguard Prevent a port from propagating topology change notifications.
