Configuring IP Multicast 763Figure 12-31. Interface Membership InformationThe Interface Membership Information page contains the following fields:• Interface — Displays the interface on which MLD proxy is enabled.• Multicast Group IP — Select the IP multicast group address for which data is to be displayed. If nogroup membership reports have been received on the selected interface you will not be able to makethis selection, and none of the non-configurable data will be displayed.• Last Reporter — The IP address of the source of the last membership report received for the IPMulticast group address on the MLD Proxy interface.• Uptime — The time elapsed since this entry was created. Displayed in hours:minutes:seconds.• State — The state of the host entry. A host can be in one of the following states:– Non-member. Does not belong to the group on the interface.– Delaying Member. Host belongs to the group on the interface and report timer is running. Thereport timer is used to send out the reports.– Idle Member. Host belongs to the group on the interface and no report timer is running.• Filter Mode — The group filter mode for the specified group on the MLD Proxy interface. Possiblevalues are Include, Exclude, or None.• Number of Sources — The number of source hosts present in the selected multicast group.Click Refresh to refresh the data on the screen with the present state of the data in the router.Displaying IPv6 MLD Membership Information Using CLI CommandsFor information about the CLI command that performs this function, see the following chapter in theCLI Reference Guide:• IPv6 Routing CommandsThe following table summarizes the equivalent CLI commands for this feature.
