562 Configuring Routing• Global Route Changes — Displays the number of route changes made to the IP Route Database byRIP. This does not include the refresh of a route's age.• Global Queries — Displays the number of responses sent to RIP queries from other systems.• Default Information Originate — Enable or Disable Default Route Advertise.• Default Metric — Sets a default for the metric of redistributed routes.This field displays the defaultmetric if one has already been set, or blank if not configured earlier. Valid values are 1 to 15.Configuring RIP1. Open the RIP Configuration page.2. Enter data in the fields as needed.3. Click Apply Changes when finished.RIP is configured, and the device is updated.Configuring RIP Using CLI CommandsFor information about the CLI commands that perform this function, see the following chapter in theCLI Reference Guide:• Routing Information Protocol (RIP) CommandsThe following table summarizes the equivalent CLI commands for this feature.Table 9-25. RIP Global Configuration CommandsCLI Command Descriptionauto-summary Enables the RIP auto-summarization mode.default-information originate Controls the advertisement of default routes.default-metric Sets a default for the metric of distributed routes.distance rip Sets the route preference value of RIP in the router.enable Resets the default administrative mode of RIP in the router (active).hostroutesaccept Enables the RIP hostroutesaccept mode.router rip Enters Router RIP mode.show ip rip Displays information relevant to the RIP router.split-horizon Sets the RIP split horizon mode.
