Eaton SEFELEC 5 Series User Manual

User manual SEFELEC 5x Series 13 v1.06DECLARATION OF CONFORMITYThe SEFELEC 5x range measuring devices marketed by the EATON Corporation comply withthe requirements of:European Directives2014/35/EU covering the safety of electrical equipment intended to be used within cer-tain voltage limits. (Low Voltage Directive)2014/30/EU covering Electromagnetic Compatibility (EMC)Harmonized standardsEN 61010-1:2010/A1:2019/AC:2019-04IEC 61010-2-034 Edition January 2017Safety rules for electrical equipment formeasurement, control and laboratory use.EN 61326-1:2013 Electrical equipment for measurement, controland laboratory use - requirement relating toEMCA copy of the Declaration of Conformity can be found at the end of this manual.QUALIFICATION OF PERSONNELThis manual is intended for persons qualified for work on electrical devices and having receivedprior training on the use of the device. The manual gives the information necessary for the prop-er assembly and use of devices in the SEFELEC 5x range.The operation manual and the corresponding technical documents must be studied and under-stood before using the device and the instructions must be observed.EXCLUSION OF LIABILITYThis documentation presents the devices in their standard version.Despite thorough checking of the content of this document, we cannot exclude possible errors.The manufacturer does not accept responsibility for inaccuracies or omissions.In case of doubt or for technical questions contact your technical representative.