Eaton SEFELEC 5 Series User Manual

User manual SEFELEC 5x Series 21 v1.06Dielectric strength, 50 VAMeasurement of the real alternating currentThe reading of the real current, linked to the resistance, is obtained through a shunt located di-rectly in the test circuitResolution 10,000 pointsAccuracy0.001 mA to 9.999 mA AC ±(3% + 100 μA)Signalling of a faultBy a PASS or FAIL colour message on the LCD display and an audible signalWith memory of Breakdown voltage.Current in case of a fault (IMAX mode)In the event of a fault, the high voltage cut occurs without overvoltage.Time delayMANUALNo time is applied to the test or the measurement. The control of the voltage is manual by actionon the up and down arrows of the LCD screen. The test or the measurement is stopped only if afault occurs or if the user requests to stop the test by pressing the red button on the front panel.PERMANENTA rise time is applied to the test and then the output voltage is equal to the set point. The test orthe measurement is stopped only if a fault occurs or if the user requests to stop the test bypressing the red button on the front panel.AUTOIn AUTO mode: The test consists of 3 successive phases (7 phases in multi-slope mode) duringwhich the voltage increases linearly up to the desired value (Rise), is maintained at the pro-grammed value (Hold) and is then gradually reduced to 0 (Fall)Rise and Fall programmable from 0.0 to 9999.0 sec. in steps of > 0.1 s.Hold programmable from 0.1 to 9999.0 sec. in steps of > 0.1 s.Accuracy +/- 20 msec.