GE N60 Instruction Manual
Also see for N60: Communications manualCommunications guideInstruction manualInstruction manualInstruction manual
                                                                                                                                                                                                                                                                                                                                                                                                                                                                            | |
Contents
|
5-20 N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUALPRODUCT SETUP CHAPTER 5: SETTINGS5Table 5-5: Security alarm settingsCyberSentry settings through the front panelSETTINGS PRODUCT SETUP SECURITYLOGIN — This setting is applicable for Device authentication only. This setting allows a user to log in with a specific role, asoutlined here. For the Supervisor role, enable the “Supervisor Role” setting.Whenever a new role is logged in, the user is prompted to enter a password. Passwords must obey the requirementsspecified earlier in the chapter in the Password Requirements section.The UR device supports five roles. Roles have theircorresponding passwords, except the Observer role, which does not require a password.The roles are defined as follows:• Administrator — Complete read/write access to all settings and commands. This role does not allow concurrentaccess. This role has an operand to indicate when it is logged on.• Engineer — Complete read/write access to all settings and commands except configuring Security settings andfirmware upgrades. This role does not allow concurrent access.• Operator — The Operator has read/write access to all settings under the Commands menu/section. This role does notexist offline.• Supervisor — This is only an approving role. This role’s authentication commits setting changes submitted byAdministrator or Engineer. The Supervisor role authenticates to unlock the UR relay for setting changes and notapprove changes after the fact. Only a Supervisor can set the Settings Lock and Firmware Lock in the Securitysettings. This role also has the ability to forcefully log off any other role and clear the security event log. This role canalso be disabled, but only through a Supervisor authentication. When this role is disabled its permissions are assignedto the Administrator role.Setting name Description / Details Min Max Default Units MinimumpermissionsFailedAuthenticationsA threshold number indicating when an alarmis set off to indicate too many failedauthentication attempts0(disabled)99 3 - AdministratorFirmware Lock A value indicating if the device can receive afirmware upgrade. If Enabled and a firmwareupgrade attempt is made, the device alarmactivates. If Disabled, the device alarm does notactivate. On each firmware upgrade this settinggoes back to the default.Disabled Enabled Enabled - AdministratorSettings Lock A value indicating if the device can accept anysettings changes. If Enabled and a settingschange attempt is made, the device alarmactivates. If Disabled, the device alarm does notactivate.Disabled Enabled Enabled - Supervisor(Administrator ifSupervisor hasbeen disabled) SECURITY LOGIN:NoneRange: Administrator, Engineer, Supervisor,Operator, Factory (for factory use only), None CHANGE LOCAL PASSWORDSSee page 5-21 SESSION SETTINGSSee page 5-21 RESTORE DEFAULTSSee page 5-21 SUPERVISORYSee page 5-22 SYSLOG IP ADDRESS:0.0.0.0Range: 0.0.0.0, 255.255.255.255 SYSLOG PORT NUMBER:514Range: 1 to 65535 |
Related manuals for GE N60
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine