Garmin G950 Pilot’s Guide for the Tecnam P2006T 190-01146-00 Rev. A278HAZARD AVOIDANCESYSTEMOVERVIEWFLIGHTINSTRUMENTSEISAUDIO PANEL& CNSFLIGHTMANAGEMENTHAZARDAVOIDANCEAFCSADDITIONALFEATURESAPPENDICESINDEXTRAFFIC MAP PAGEThe Traffic Map Page is specialized to show surrounding TIS traffic data in relation to the aircraft’s currentposition and altitude, without clutter from the basemap. Aircraft orientation on this map is always heading upunless there is no valid heading. Map range is adjustable with the RANGE Knob from 2 to 12 nm, as indicatedby the map range rings.The traffic mode is annunciated in the upper left corner of the Traffic Map Page. When the aircraft is on theground, TIS automatically enters Standby Mode. Once the aircraft is airborne, TIS switches from Standby toOperating Mode and the G950 begins to display traffic information. Refer to the System Status discussion formore information.Displaying traffic on the Traffic Map Page:1) Turn the large FMS Knob to select the Map Page Group.2) Turn the small FMS Knob to select the Traffic Map Page.3) Confirm TIS is in Operating Mode:Press the OPERATE Softkey to begin displaying traffic.Or:a) Press the MENU Key.b) Select ‘Operate Mode’ (shown if TIS is in Standby Mode) and press the ENT Key.Figure 6-12 Traffic Map PageNon-ThreatTraffic“Non-Bearing” Traffic(System Unable toDetermine Bearing)Distance is 8.0 nm,1100’ Above,DescendingNon-ThreatTrafficTraffic Advisory400’ Below,ClimbingTraffic StatusBannerTraffic Mode Annunciation“TIS Not Available”Voice Alert StatusRangeMarkingRingsSelectto Mute“TIS NotAvailable”Voice Alert