Garmin G950 Pilot’s Guide for the Tecnam P2006T 190-01146-00 Rev. A42SYSTEM OVERVIEWSYSTEMOVERVIEWFLIGHTINSTRUMENTSEISAUDIO PANEL& CNSFLIGHTMANAGEMENTHAZARDAVOIDANCEAFCSADDITIONALFEATURESAPPENDICESINDEX4) Press the CLR Key to clear the message text. If the CLR Key is pressed again, the message is restored.5) Press the ENT Key to confirm message deletion.Scheduler messages appear in the Alerts Window on the PFD and cause the ALERTS Softkey label to changeto ‘ADVISORY’. Pressing the ADVISORY Softkey opens the Alerts Window and acknowledges the schedulermessage. The softkey reverts to the ‘ALERTS’ label and when pressed, the Alerts Window is removed fromthe display and the scheduler message is deleted from the message list.Figure 1-36 PFD Alerts WindowPFD1.7 DISPLAY bACkLIGHTINGBacklighting of the PFD and MFD, and Audio Panel keys can be adjusted automatically or manually. Theautomatic setting (default) uses photocells to adjust for ambient lighting conditions. Photocell calibration curvesare pre-configured to optimize display appearance through a broad range of cockpit lighting conditions. Innormal display mode, backlighting can only be adjusted from the PFD. In Reversionary Mode, it can be adjustedfrom the remaining display(s).Adjusting display backlighting manually:1) Press the PFD MENU Key to display the PFD Setup Menu. ‘AUTO’ is now highlighted next to ‘PFD DSPL’. Noother window can be displayed on the PFD while the PFD Setup Menu is displayed. Pressing the MENU Keywhile any other PFD window is displayed does not display the PFD Setup Menu.2) Turn the small FMS Knob to select ‘MANUAL’ and press the ENT Key. The intensity value is now highlighted.3) Use the FMS Knob to enter the desired backlighting then press the ENT Key.4) Turn the large FMS Knob to highlight ‘AUTO’ next to ‘MFD DSPL’ and repeat steps 2-4.5) To remove the menu, press the CLR or MENU Key.