102Section 6GPS ReceiverReference5. To enter a name for the new waypoint, highlight thewaypoint name field and press ENTER. Use theARROW or phone keypad to enter the waypointname and press ENTER when finished.6. To enter position coordinates for the new waypoint,highlight the waypoint coordinates field and pressENTER. Use the ARROW or phone keypad to enterthe position coordinates and press ENTER whenfinished. (For lat/lon coordinates, enter both thelatitude and longitude information before pressingENTER.) Or,7. To create the new waypoint by referencing anotherposition, highlight the reference waypoint namefield and press ENTER. Use the ARROW or phonekeypad to enter the name of the reference waypointand press ENTER. (If the reference waypoint namefield is left blank, your present position will be usedas the reference position.) Use the same procedureto enter the bearing (BRG) and distance (DST) fromthe reference waypoint to the new waypoint. PressENTER after each data item is selected with theARROW keypad.8. To save the new waypoint in memory, highlight‘Done’ and press ENTER.Waypoint List OptionsThe Waypoint Options were displayed using the firstthree steps above. In addition to ‘New Waypoint’, thereare additional options which vary depending on whetheryou are viewing Jeppesen database waypoints or user-defined waypoints:New Waypoint — allows you to name and define awaypoint by entering the bearing and distance fromanother reference waypoint or by entering the latitude/longitude.Show Map — allows you to view the map areaaround the selected waypoint. While viewing the mapdisplay, you can use the IN and OUT zoom keys to seeadditional detail.Select the ‘Show Map’option to display themap area around aselected waypoint.Once ‘Show Map’ isselected use the panningpointer and the IN/OUTzoom keys to view thedesired area in detail.