46Section 4Cell PhoneReferencePassword Program-ming for Lock andSecurity PasswordsTo program Lock and Security Passwords:1. Highlight the ‘Change Password’ field and pressENTER. A ‘Change Password’ window will appear.2. Press ENTER and choose ‘Security’ from the pop upmenu, then cursor to the Security Field.3. If you are entering a password for the first time,move to the Security field and enter the securitypassword (if you haven’t created a securitypassword enter 1234567).4. Press ENTER and cursor to the ‘New’ field to enteryour new security password. The password must befrom one to eight characters and entered from thephone keypad.5. Press ENTER to move down to the ‘Retype’ fieldand re-enter the password. Press ENTER to record.If the entry numbers, disguised by asterisksdisappears, your password has been changed. Ifnot, enter again.6. Repeat this process for the ‘Lock’ password.7. Press QUIT to return to the security Setup page.You can program the NavTalk Pilot to lock automati-cally each time you turn it On. Whenever you encountera feature with a Padlock icon you must always enter thesecurity password to access or change any programming.To use Auto Lock:1. In the Security directory highlight the Padlock Iconin the Auto Lock field and press ENTER to pop upthe security password box. Press ENTER again tokey in the Security Password.2. Press ENTER to return to the ‘Auto Lock’ field. ThePadlock icon will be open and highlighted. Cursorto the ‘Auto Lock’ box and press ENTER to activatethe Auto Lock feature.3. Cursor back to the Padlock icon and press ENTERto pop up the security password box. Re-enter thepassword and press ENTER to return to the AutoLock field with the icon in the locked position.Auto Lock Selected.Enter Security Passwordto secure Auto Lock andCall Blocking