51Section 4Cell PhoneReferenceThe Minute Reminderwill emit two beeps eachminute unless turned OffTo enable Remote Command:1. Press the MENU key twice to access the MainMenu.2. Cursor to the Setup Menu option and press ENTER.3. Select the System Setup Page tab, then cursor downto the padlock icon above the ‘Remote Command’field.4. If the icon is locked, highlight it and press ENTER topop up the Security window. Enter your Lock Codeto open the lock. If the icon is not locked cursor tothe ‘Remote Command’ field and press ENTER toenable or disable this feature.To “Query” for a GPS location:1. Dial the number of a NavTalk Pilot unit or similarlyprogrammed cellular device. When the callednumber answers press MENU and cursor to ‘QueryLocation’ and press ENTER. You will hear theDTMF tones and the “Transferring Location”message will appear.2. When the DTMF tone has been recognized, theother unit will transmit the GPS location to yourunit, but only if it has the ‘Remote Command’feature enabled. If it is not, the tones will stop andthe new position will not be acknowledged. If thecall is disconnected before the transfer is complete,the new position will not be acknowledged.3. The new position is acknowledged by a confirma-tion message and the location marked as a “Phone”waypoint on the Map Page. Refer to Page 56 formore information.Setting Call TimersCall Timers are useful for recording the time of thelast call you made, the elapsed time of all calls for ameasured time period, and the total lifetime use of yourNavTalk Pilot call time. You can also set the unit to signaleach time a minute of your current call has elapsed.