43Section 4Cell PhoneReferenceProgramming Phone Setup (Answer Mode,Auto Redial, Auto Data and Calling Card PIN)There are three Answer Mode options, Manual Answer,Auto Answer (Hands-Free, for headsets) and Auto Pager.When Auto Pager answers, the microphone is muted andthe unit emits a beep tone to indicate the Auto Pager featureis active. The caller then enters their phone number that isplaced in the ‘Missed Calls’ list along with a date/timestamp. Inform frequent callers about the Auto Pager beeptone signal. Pressing SEND pre-empts Auto Pager.Pressing END before answering any call cancels AutoAnswer or Auto Pager. These two modes then resume forsubsequent calls. Auto Redial allows you to redial thenumber you are calling up to nine times.Auto Data provides for location data transmissionwithout ringing the phone or requiring the SEND key tobe pressed, and without displaying messages aboutlocation transfer. If data is not detected within threeseconds, the call will ring for up to 50 seconds and istreated according to user selection (Auto Answer, AutoPager or Manual Answer). Auto Data selection can belocked and unlocked using the Security Password.To program Answer Mode:1. Use the down arrow key to highlight the field.2. Press ENTER to display Manual Answer, Auto-Answer or Auto-Pager from the pop-up menu.3. If choosing Auto Answer or Auto Pager, press theright arrow key to move to the Number of Ringsfield, press ENTER and then use the up arrow keyor phone keypad to enter the number of rings. Youare limited to nine rings. Press ENTER to store yourselection.Highlight ‘Answer Mode”and press ENTER todisplay the pop-upOptions Menu for phoneanswering modes.Highlight the desiredoption and press ENTER.The Auto Data and PINselection fields requireunlocking, using theSecurity Password
