Service Manual February 2017Checklist B Procedures30 S-80 • S-85 • S-80X Part No. 1259369GT9 Remove the battery vent caps and check thespecific gravity of each battery cell with ahydrometer. Note the results.10 Check the ambient air temperature and adjustthe specific gravity reading for each cell asfollows:• Add 0.004 to the reading of each cell forevery 10° F / 5.5° C above 80° F / 26.7° C.• Subtract 0.004 from the reading of each cellfor every 10° F / 5.5° C below 80° F / 26.7°C.Result: All battery cells display a specificgravity of 1.277 or greater. The battery is fullycharged. Proceed to step 11.Result: One or more battery cells display aspecific gravity from 1.218 to 1.269. Thebattery is still usable, but at a lowerperformance. The battery will need to berecharged more often. Proceed to step 11.Result: One or more battery cells display aspecific gravity from 1.217 to 1.173. Thebattery is approaching the end of its life.Proceed to step 11.Result: The difference in specific gravityreadings between cells is greater than 0.1 ORthe specific gravity of one or more cells is lessthan 1.177. Replace the battery.11 Check the battery acid level. If needed,replenish with distilled water to 1/8 inch / 3 mmbelow the bottom of the battery fill tube. Do notoverfill.12 Install the vent caps and neutralize anyelectrolyte that may have spilled.B-2Inspect the Electrical WiringGenie specifications require that this procedure beperformed every 250 hours or quarterly, whichevercomes first.Maintaining electrical wiring in good condition isessential to safe operation and good machineperformance. Failure to find and replace burnt,chafed, corroded or pinched wires could result inunsafe operating conditions and may causecomponent damage.Electrocution/burn hazard.Contact with electrically chargedcircuits could result in death orserious injury. Remove all rings,watches and other jewelry.1 Open the engine side turntable cover.2 Remove the engine tray retaining fastenerlocated under the engine tray. Swing theengine tray out and away from the machine.1 engine tray anchor hole2 engine tray retaining fastener
