February 2017 Service ManualChecklist C ProceduresPart No. 1259369GT S-80 • S-85 • S-80X 557 Measuring Tape: Measure the distancebetween the center of the pivot pins as shown,201.75 inches / 512 cm± 2.0 inch / 5 cm.Digital Protractor: Place the digital protractoron the turntable chassis and reset theprotractor to 0°. Place the protractor on top ofthe primary boom. The protractor shoulddisplay 58° ± 2°.Result: The primary boom angle is not withinspecifications.Consult Genie Product Support.1 Measure between the centers of thesepivot pinsPlatform controls:Note: Start this procedure with the boom fullyretracted and in the stowed position.1 Pull out the red Emergency Stop button to theon position and start the engine.2 Select the restricted maximum platformcapacity with the toggle switch.1 restricted maximum platform capacity2 unrestricted maximum platform capacity3 Raise the primary boom until it is fullyelevated.4 Extend the primary boom until it is fullyextended.5 Lower the primary boom until it stops.Result: The boom will automatically stop after10 degrees and the unrestricted platformcapacity light will flash.Result: The primary boom does not stop after10 degrees. Calibrate the boom angle sensor.Refer to Repair Procedure, How to Calibratethe Boom angle Sensor.
