1-6Configuring Member Ports for a Smart Link GroupYou can configure member ports for a smart link group either in smart link group view or in interface view.The configurations made in these two views have the same effect.In smart link group viewFollow these steps to configure member ports for a smart link group in smart link group view:To do… Use the command… RemarksEnter system view system-view —Create a smart link group and entersmart link group view smart-link group group-id —Configure member ports for a smart linkgroupport interface-typeinterface-number { master |slave }RequiredIn interface viewFollow these steps to configure member ports for a smart link group in interface view:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet interface view or layer 2aggregate interface viewinterface interface-typeinterface-number —Configure member ports for a smart linkgroupport smart-link group group-id{ master | slave } RequiredConfiguring Role Preemption for a Smart Link GroupFollow these steps to configure role preemption for a smart link group:To do… Use the command… RemarksEnter system view system-view —Create a smart link group and entersmart link group view smart-link group group-id —Enable role preemption preemption mode role OptionalEnabled by default.Configure the preemption delay preemption delay delay-time Optional1 second by defaultThe preemption delay configuration takes effect only after role preemption is enabled.
