1-10To do… Use the command… RemarksSpecify a log host andconfigure the parameters whensystem information is output tothe log hostinfo-center loghost host-ip[ port port-number ] [ channel{ channel-number |channel-name } | facilitylocal-number ] *RequiredBy default, the system does notoutput information to a log host.If you specify to output systeminformation to a log host, thesystem uses channel 2(loghost) by default.The value of the port-numberargument should be the sameas the value configured on thelog host, otherwise, the log hostcannot receive systeminformation.Configure the output rules ofthe system informationinfo-center source{ module-name | default }channel { channel-number |channel-name } [ debug { levelseverity | state state } * | log{ level severity | state state } * |trap { level severity | statestate } * ] *OptionalRefer to Default output rules ofsystem information.Specify the source IP addressfor the log informationinfo-center loghost sourceinterface-type interface-numberOptionalBy default, the source interfaceis determined by the matchedroute, and the primary IPaddress of this interface is thesource IP address of the loginformation.Configure the format of the timestamp for system informationoutput to the log hostinfo-center timestamploghost { date | no-year-date |none }Optionaldate by default.Outputting System Information to the Trap BufferThe trap buffer receives the trap information only, and discards the log and debugging information evenif you have configured to output them to the trap buffer.To do… Use the command… RemarksEnter system view system-view —Enable information center info-center enable OptionalEnabled by defaultName the channel with aspecified channel numberinfo-center channelchannel-number namechannel-nameOptionalRefer to Table 1-2 for defaultchannel names.
