1-9Static Routing, Track and the Interface Management Module CollaborationConfiguration ExampleNetwork requirementsz As shown in Figure 1-3, the next hop of the static route from Switch A to Switch C is Switch B.z Configure Static Routing, Track and the Interface Management Module collaboration on Switch Ato implement real-time monitoring of the validity of the static route to Switch C.Figure 1-3 Network diagram for Static Routing, Track and the Interface Management Modulecollaboration configurationVlan-int210.1.1.1/24Vlan-int210.1.1.2/24Vlan-int310.2.1.1/24Switch CVlan-int310.2.1.2/24Switch BSwitch AConfiguration procedure1) Configure the IP address of each interface as shown in Figure 1-3.2) Configure a static route on Switch A and associate it with the Track object.# Configure the address of the next hop of the static route to Switch C as 10.2.1.1, and configure thestatic route to associate with Track object 1. system-view[SwitchA] ip route-static 10.1.1.2 24 10.2.1.1 track 13) Configure the Track and Interface Management on Switch A.# Create a Track object and associate it with the interface management module to monitor the Layer 3protocol status of an interface[SwitchA] track 1 interface vlan-interface 3 protocol ipv44) Verify the configuration# Display information of the Track object on Switch A.[SwitchA] display track allTrack ID: 1Status: PositiveReference object:Track interface :Interface status : InsertedInterface : Vlan-interface1Protocol : IPv4# Display the routing table of Switch A.[SwitchA] display ip routing-tableRouting Tables: Public
