1-3z When configuring a static route, the static route does not take effect if you specify the next hopaddress first and then configure it as the IP address of a local interface, such as VLAN interface.z If you do not specify the preference when configuring a static route, the default preference will beused. Reconfiguring the default preference applies only to newly created static routes.z If the destination IP address and mask are both configured as 0.0.0.0 with the ip route-staticcommand, the route is the default route.z For detailed information about track, refer to Track Configuration in the System Volume.Displaying and Maintaining Static RoutesTo do… Use the command… RemarksDisplay the currentconfiguration information display current-configurationDisplay the brief information ofthe IP routing table display ip routing-tableDisplay the detailedinformation of the IP routingtabledisplay ip routing-table verboseView information of staticroutesdisplay ip routing-table protocol static[ inactive | verbose ]Available in anyviewDelete all the static routes delete static-routes all Available Insystem viewStatic Route Configuration ExampleBasic Static Route Configuration ExampleNetwork requirementsThe IP addresses and masks of the switches and hosts are shown in the following figure. Static routesare required for interconnection between any two hosts.
