1-9You are recommended not to run the shutdown command and then the undo shutdown command ona member port of the aggregation group corresponding to an aggregate interface that is already shutdown. Otherwise, when the member port is brought up, the selected state of the remote port will beaffected.Configuring a Load Sharing Mode for Load-Sharing LinkAggregation GroupsThe hash algorithm is adopted to calculate load sharing for load-sharing link aggregation groups. Thecalculation could be based on service port numbers, IP addresses, MAC addresses, incoming ports, orany combinations of them depending on the adopted load sharing mode. You can change the loadsharing mode of a link aggregation group to change the criteria used for calculation as needed.Follow these steps to configure the global load sharing mode for link aggregation groups:To do... Use the command... RemarksEnter system view system-view —Configure the global linkaggregation load sharingmodelink-aggregation load-sharing mode{ destination-ip | destination-mac |destination-port | ingress-port |source-ip | source-mac |source-port } *OptionalBy default, the hash keysfor Layer 2 packets aresource/destination MACaddresses, and those forLayer-3 packets aresource/destination IPaddresses andsource/destination MACaddresses.The setting you madeaffects all load-sharinglink aggregation groups.Currently, the hash keys for a switch are source IP addresses, destination IP addresses, source MACaddresses, destination MAC addresses, source ports, destination ports, or the combination of thesefields carried in packets. The ingress-port keyword can be used as a hash key only when it is usedalone.Displaying and Maintaining Link AggregationTo do... Use the command... RemarksDisplay the local system ID display lacp system-id Available in any viewDisplay the global oraggregation group-specific loadsharing modedisplay link-aggregationload-sharing mode Available in any view
