1-8125 ASCII mode data connection already open, transfer starting for /config.cfg.226 Transfer complete.FTP: 3494 byte(s) sent in 5.646 second(s), 618.00 byte(s)/sec.[ftp] bye# Specify newest.bin as the main startup file to be used at the next startup. boot-loader file newest.bin main# Reboot the device, and the startup file is updated at the system reboot. rebootThe startup file used for the next startup must be saved under the root directory of the storage medium.You can copy or move a file to the root directory of the storage medium. For the details of theboot-loader command, refer to Device Management Commands in the System Volume.Configuring the FTP ServerConfiguring FTP Server Operating ParametersThe FTP server uses one of the two modes to update a file when you upload the file (use the putcommand) to the FTP server:z In fast mode, the FTP server starts writing data to the storage medium after a file is transferred tothe memory. This prevents the existing file on the FTP server from being corrupted in the event thatanomaly, power failure for example, occurs during a file transfer.z In normal mode, the FTP server writes data to the storage medium while receiving data. Thismeans that any anomaly, power failure for example, during file transfer might result in filecorruption on the FTP server. This mode, however, consumes less memory space than the fastmode.Follow these steps to configure the FTP server:To do… Use the command… RemarksEnter system view system-view —Enable the FTP server ftp server enable RequiredDisabled by default.Use an ACL to control FTPclients’ access to the device ftp server acl acl-numberOptionalBy default, no ACL is used tocontrol FTP clients’ access tothe device.
