6-6[Sysname-GigabitEthernet1/0/1] qos wrr 3 group 1 weight 70[Sysname-GigabitEthernet1/0/1] qos wrr 4 group 2 weight 20[Sysname-GigabitEthernet1/0/1] qos wrr 5 group 2 weight 50[Sysname-GigabitEthernet1/0/1] qos wrr 6 group 2 weight 70[Sysname-GigabitEthernet1/0/1] qos wrr 7 group 2 weight 100Configuring SP+WRR QueuesConfiguration ProcedureFollow these steps to configure SP + WRR queues:To do… Use the command… RemarksEnter system view system-view —Enter portviewinterface interface-typeinterface-numberEnter portview orport groupview Enter portgroup viewport-group manualport-group-namePerform either of the two operations.The configuration performed inEthernet interface view applies to thecurrent port only. The configurationperformed in port group view appliesto all the ports in the port group.Configure SP queuescheduling qos wrr queue-id group sp RequiredConfigure WRR queueschedulingqos wrr queue-id groupgroup-id weightschedule-valueRequiredWhen you use the SP+WRR queue scheduling algorithm, make sure that queues in the samescheduling group are consecutive.Configuration Example1) Network requirementsz Configure to adopt SP+WRR queue scheduling algorithm on GigabitEthernet1/0/1.z Configure queue 0 and queue 1 on GigabitEthernet1/0/1 to be in SP queue scheduling group.z Configure queue 2, queue 3, and queue 4 on GigabitEthernet1/0/1 to be in WRR queue schedulinggroup 1, with the weight being 20, 70, and 100 respectively.z Configure queue 5, queue 6, and queue 7 on GigabitEthernet1/0/1 to be in WRR queue schedulinggroup 2, with the weight being 10, 50, and 80 respectively.2) Configuration procedure# Enter system view. system-view# Enable the SP+WRR queue scheduling algorithm on GigabitEthernet1/0/1.
