1-9To do… Use the command… RemarksEnter portgroup viewport-group manualport-group-namez In port group view, thesubsequent configurationsapply to all ports in the portgroup.z In Layer-2 aggregate interfaceview, the subsequentconfigurations apply to theLayer-2 aggregate interfaceand all its member ports.Configure the link type of theport(s) as hybrid port link-type hybrid RequiredAssign the hybrid port(s) tothe specified VLAN(s)port hybrid vlan vlan-id-list{ tagged | untagged }RequiredBy default, a hybrid port allowsonly packets of VLAN 1 to passthrough untagged.Configure the default VLAN ofthe hybrid port port hybrid pvid vlan vlan-id OptionalVLAN 1 is the default by default.z To change the link type of a port from trunk to hybrid or vice versa, you must set the link type toaccess first.z Before assigning a hybrid port to a VLAN, create the VLAN first.z After configuring the default VLAN for a hybrid port, you must use the port hybrid vlan commandto configure the hybrid port to allow packets from the default VLAN to pass through, so that theegress port can forward packets from the default VLAN.Displaying and Maintaining VLANTo do... Use the command… RemarksDisplay VLAN information display vlan [ vlan-id1 [ to vlan-id2 ] | all |dynamic | reserved | static ] Available in any viewDisplay VLAN interfaceinformationdisplay interface vlan-interface[ vlan-interface-id ] Available in any viewDisplay hybrid ports or trunkports on the device display port { hybrid | trunk } Available in any viewClear statistics on a port reset counters interface [ interface-type[ interface-number ] ] Available in user viewThe reset counters interface command can be used to clear statistics on a VLAN interface. For moreinformation, refer to Ethernet Interface Commands in the Access Volume.
