1-7To do... Use the command... RemarksConfigure theaggregation group towork in dynamicaggregation modelink-aggregation mode dynamicRequiredBy default, an aggregation groupworks in static aggregationmode.Exit to system view quit —Enter Ethernet interfaceviewinterface interface-typeinterface-numberAssign the Ethernetinterface to theaggregation groupport link-aggregation groupnumberRequiredRepeat the two steps to assignmultiple Ethernet interfaces tothe aggregation group.Assign the port a LACPpriority lacp port-priority port-priorityOptionalBy default, the LACP priority of aport is 32768.Changing the LACP priority of aport may affect theselected/unselected state of theports in the dynamic aggregationgroup.z Removing a dynamic aggregate interface also removes the corresponding aggregation group. Atthe same time, the member ports of the aggregation group, if any, leave the aggregation group.z To guarantee a successful dynamic aggregation, ensure that the peer ports of the portsaggregated at one end are also aggregated. The two ends can automatically negotiate the selectedstate of the ports.Configuring an Aggregate InterfaceYou can perform the following configurations for an aggregate interface:z Configuring the Description of an Aggregate Interfacez Enabling LinkUp/LinkDown Trap Generation for an Aggregate Interfacez Shutting Down an Aggregate InterfaceConfiguring the Description of an Aggregate InterfaceFollow these steps to configure the description of an aggregate interface:To do... Use the command... RemarksEnter system view system-view —Enter Layer-2 aggregateinterface viewinterface bridge-aggregationinterface-number —
