1-33Configuring Attributes Related to the Data Sent to HWTACACS ServerFollow these steps to configure the attributes related to the data sent to the HWTACACS server:To do… Use the command… RemarksEnter system view system-view —Enter HWTACACS scheme view hwtacacs schemehwtacacs-scheme-name —Specify the format of theusername to be sent to anHWTACACS serveruser-name-format{ keep-original |with-domain |without-domain }OptionalBy default, the ISP domainname is included in theusername.Specify the unit for data flows orpackets to be sent to anHWTACACS serverdata-flow-format { data{ byte | giga-byte | kilo-byte| mega-byte } | packet{ giga-packet | kilo-packet |mega-packet |one-packet } }*OptionalThe defaults are as follows:byte for data flows, andone-packet for data packets.In HWTACACSscheme view nas-ip ip-addressquitSet the sourceIP address ofthe device tosendHWTACACSpackets In system viewhwtacacs nas-ip ip-addressUse either commandBy default, the outbound portserves as the source IPaddress to send HWTACACSpackets.z If an HWTACACS server does not support a username with the domain name, you can configurethe device to remove the domain name before sending the username to the server.z The nas-ip command in HWTACACS scheme view is only for the current HWTACACS scheme,while the hwtacacs nas-ip command in system view is for all HWTACACS schemes. However, thenas-ip command in HWTACACS scheme view overwrites the configuration of the hwtacacsnas-ip command.Setting Timers Regarding HWTACACS ServersFollow these steps to set timers regarding HWTACACS servers:To do… Use the command… RemarksEnter system view system-view —Enter HWTACACS schemeviewhwtacacs schemehwtacacs-scheme-name —Set the HWTACACS serverresponse timeout timertimer response-timeoutsecondsOptional5 seconds by defaultSet the quiet timer for theprimary server timer quiet minutes Optional5 minutes by default
