195 MEMORY CHANNELSN Memory channel programmingq Push [V/M] to select the VFO mode.w Set a desired frequency:± Select a desired band with [BAND].± Set a desired frequency with [DIAL].± Set other data (e.g. frequency offset, duplex direction, tonesquelch, etc.), if desired.e Hold down [S.MW](V/M) for 1 second to enter the selectmemory write mode.• 1 short and 1 long beep sound.• The “ ” icon and memory channel number blink.r Rotate [DIAL] to select a desired channel.• Scan edge channels, 00A/B to 24A/B can also be selected.• While holding down [FUNC], rotate [DIAL] to select memorychannels in 10 channel steps.t Hold down [S.MW](V/M) for 1 second.• 3 beeps sound• The memory channel number automatically increases whenholding down [S.MW](V/M) after programming.NOTE: Push [V/M] to cancel programming and exit theselect memory write mode, before memory programmingis finished.RotateHold down for 1 sec. to select channel 20.Hold down for 1 sec. to program.The VFO mode Enter the select memory write mode.Return to the VFO mode.[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (a blank channel).
