Icom IC-R6 Instruction Manual

Also see for IC-R6: Price list Instruction manual Instruction manual Service manual

Contents

Icom IC-R6 Instruction Manual Manual pdf 43 page image

306SCAN OPERATION12345678910111213141516N Scan edges programmingScan edges can be programmed in the same manner asmemory channels. Scan edges are programmed into scanedge memory channels, 00A/00B to 24A/24B.q Push [V/M] to select the VFO mode.w Set a desired frequency:± Push [BAND] to select a desired band.± Rotate [DIAL] to set a desired frequency.± Set other data (e.g. offset frequency, duplex direction, tonesquelch, etc.), if desired.eHold down [S.MW](V/M) for 1 second to enter the selectmemory write mode.• 1 short and 1 long beep sounds.• The “ ” icon and memory channel number blink.r Rotate [DIAL] to select a desired programmed scan edgechannel from 00A to 24A.t Hold down [S.MW](V/M) for 1 second.• 3 beeps sound• The matched “B” channel is automatically selected when hold-ing down [S.MW](V/M) after programming.y To program a frequency for the other pair of scan edges,00B or 24B, repeat steps w and r.• If the same frequency is programmed into a pair of scan edges,programmed scan will not function.RotateHold down for 1 sec. to select channel 03A.Hold down for 1 sec. to program.The VFO mode Enter the select memory write mode.Return to the VFO mode.[EXAMPLE]: Programming 145.370 MHz into scan edge channel 03A (a blank channel).