316 SCAN OPERATIONN Memory/all bank/bank link/bank scanq Push [V/M] to select the memory mode.w Set the squelch level.e Hold down [SCAN](MODE) for 1 second to enter the scantype selection mode.r Rotate [DIAL] to select a desired scanning type.• Select “M-ALL” for all memory scan, “B-ALL” for all bank scan,“B-LINK” for bank link scan or “BANK-x” for bank scan (x= A toR, T, U, W, Y; only programmed bank groups are displayed).[DIAL]• All memory scan• All bank scan• Bank link scan• Bank scanSelectable between“A” to “R,” “T,” “U,” “W” or “Y,”if programmedRotateHold downfor 1 sec.t To start the scan, push [SCAN](MODE).• The scan pauses when a signal is received.• Rotate [DIAL] to change the scanning direction. This alsoresumes scanning.• Push [SCAN](MODE) again to stop the scan.During memory/all bank/bank link scanDuring bank scanIMPORTANT!: To perform a memory or bank scan, two ormore memory/bank channels MUST be programmed,otherwise the scan will not start.
