Icom IC-R6 Instruction Manual

Also see for IC-R6: Price list Instruction manual Instruction manual Service manual

Contents

Icom IC-R6 Instruction Manual Manual pdf 51 page image

387PRIORITY WATCH7D VFO scan watchq Select the channel(s) to be watched.For memory channel watch:Select a desired memory channel.For memory scan watch:± Push [V/M] to select the memory mode.± Hold down [SCAN](MODE) for 1 second to enter thescan type selection mode.± Rotate [DIAL] to select a desired scan type, then push[SCAN](H/M/L) again to start the memory/bank scan.w Hold down [SET](TS) for 1 second to enter the Set mode.e Rotate [DIAL] to select the priority watch set item.rWhile holding down [FUNC], rotate [DIAL] to select “ON.”• Select “BELL” if the priority beep function is desired.After 1 sec.t Push [SET](TS) to exit the Set mode and start the watch.• The “PRIO” icon appears.yHold down [SCAN](MODE) for 1 second to enter scantype selection mode.uRotate [DIAL] to select a desired scan type from “ALL,”“BAND,” “P-LINK x (x= 0 to 9)” or “PROGxx (xx= 0–24).”i Push [SCAN](MODE) to start the VFO scan watch.• The receiver checks the memory channel(s) every 5 seconds.• The watch resumes according to the selected scan resume set-ting. (p. 31)During VFO watchSearches VFO frequen-cies for 5 seconds.Pauses on a memorychannel when a signal isreceived.During VFO scan watch with the priority beepA beep tone sounds and “S” icon blinks when a signalis received on a memory channel.o Push [TS] to cancel the watch and scan.