Icom IC-R6 Instruction Manual
Also see for IC-R6: Price listInstruction manualInstruction manualService manual
                                                                                        | |
Contents
| 
296 SCAN OPERATIONq Push [V/M] to select the VFO mode.• Push [BAND] to select a desired frequency band.w Set the squelch level.eHold down [SCAN](MODE) for 1 second to enter the scantype selection mode.r Rotate [DIAL] to select a desired scanning type.• Select “ALL” for full scan, “BAND” for band scan, “P-LINK x” forprogrammed link scan (x= 0 to 9), “PROGxx” for programmedscan (xx= 0 to 24; only programmed scan edge numbers aredisplayed).[DIAL]Selectable between“0” to “24” if programmedSelectable between“0” to “9” if programmed• Full scan• Band scan• Program link scan• Program scanRotateHold downfor 1 sec.t To start the scan, push [SCAN](MODE).• The scan pauses when a signal is received.• Rotate [DIAL] to change the scanning direction. This alsoresumes scanning.• Push [SCAN](MODE) again to stop the scan.During full/band scan During programmed/link program scanNOTE: Instead of doing steps e to t, while holdingdown [SCAN](MODE), rotate [DIAL] to select a desiredscan type. In this case, the scan starts after releasing[SCAN](MODE).About the scanning steps: The VFO mode, the selectedtuning step in each frequency band is used during thescan.N Full/band/programmed link/programmed scan |
Related manuals for Icom IC-R6
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine