185 REPEATER OPERATION■ Offset frequencyWhen communicating through a repeater, the transmit fre-quency is shifted from the receive frequency by an amountdetermined by the offset frequency.q Push [A• FUNC ], then push [8• SET] to enter SET MODE.wPush [YY] or [ZZ] several times until “±” and offset frequencyappear.eRotate [VOL] to select the desired offset frequency.• Selectable steps are the same as the pre-set tuning steps.• The unit of the displayed offset frequency is “MHz.”rPush [✱• ENT ] (or [D• CLR ]) to set the offset frequencyand exit SET MODE.■ Subaudible tonesSome repeaters require subaudible tones to be accessed.Subaudible tones are added to your normal signal and mustbe set in advance.qPush [A• FUNC ], then push [8• SET] to enter SET MODE.wPush [YY] or [ZZ] one or more times until “rt” appears.e Rotate [VOL] to select the desired subaudible tone.rPush [✱•ENT ] (or [D• CLR ]) to set the selected tone andexit SET MODE.• Available subaudible tone frequencies (unit: Hz)67.069.371.974.477.085.488.591.594.897.4100.0103.579.782.5107.2110.9114.8118.8123.0127.3131.8136.5141.3146.2151.4156.7159.8162.2165.5167.9171.3173.8177.3179.9183.5186.2189.9192.8196.6199.5203.5206.5210.7218.1225.7229.1233.6241.8250.3254.1USING SET MODEUSING SET MODE