Icom IC-V82 Instruction Manual

Also see for IC-U82: Addendum Specifications Service manual Instruction manual Instruction manual

Contents

4010 PAGER/CODE SQUELCH■ Pager operationD Calling a specific stationq Program the code channel in advance (p. 39).w Set the operating frequency.• Set the volume and squelch to the desired level as in normal op-eration.e Push [A• FUNC ], then push [0• OPT].• Rotate [VOL] to select “dtm.PG,” if “dtm.CS” or “dtm.OF” ap-pears.r Select the desired transmit code channel:➥ Push and hold [0• OPT] for 1 sec. to enter the code se-lection mode.➥ Rotate [VOL] to select the desired code channel.➥ Push [✱•ENT ] to return to previous mode.• 100 MHz digit shows “P.”t Push [PTT] to transmit the pager code.y Wait for an answer back.• When the transceiver receives an answer back code, the func-tion display shows the other member’s ID or group code.u After confirming a connection, push [A• FUNC ] and [0• OPT]to enter OPTION SET MODE, then rotate [VOL] to select thecode squelch operation “dtm.CS,” or non-selective callingsystem “dtm.OF.”• DO NOT push any digit keys while code channels C0 to C6 aredisplayed, otherwise code channel contents will be changed.i Communicate with the other party as normal: push [PTT]to transmit; release to receive.D Waiting for a call from a specific stationq Set the operating frequency.w Push [A• FUNC ], then push [0• OPT].➥ Rotate [VOL] to select “dtm.PG,” if “dtm.CS” or“dtm.OF” appears.➥ Push [✱•ENT ] to return to previous mode.• 100 MHz digit shows “P.”e Wait for a call.• When receiving a call, the caller’s ID or group code appears asshown at next page.• DO NOT push any digit keys while code channels C0 to C6 aredisplayed, otherwise code channel contents will be changed.r Push [PTT] to send an answer back call and display theoperating frequency.t After confirming a connection, push [A• FUNC ] and [0• OPT]to enter OPTION SET MODE, then rotate [VOL] to select thecode squelch operation “dtm.CS,” or non-selective callingsystem “dtm.OF.”