7113CLONING1213q Connect the OPC-474 CLONING CABLE to the [SP] jack ofthe master and sub-transceivers.• The master transceiver is used to send data to the sub-trans-ceiver.w While pushing [A• FUNC ] and [YY],turn power ON to enter cloningmode (master transceiver only—power ON for sub-transceiver).• “CLONE” appears and the transceiversenter the clone standby condition.e Push [PTT] on the master trans-ceiver.• “CL OU” appears in the master transceiver’s display and S-meterindicator shows that data is being transferred to the sub-trans-ceiver.• “CL IN” appears automatically in the sub-transceiver’s displayand S-meter indicator shows that data is being received fromthe master transceiver.r When cloning is finished, turn power OFF, then ON againto exit cloning mode.NOTE: DO NOT push [PTT] on the sub-transceiver duringcloning. This will cause a cloning error.PWRFUNCACloning allows you to quickly and easily transfer the pro-grammed contents from one transceiver to another trans-ceiver.■ Transceiver-to-transceiver cloning AT POWER ON
