4110PAGER/CODE SQUELCH10• PERSONAL CALLSThis display appears when you are called with your ID codeand the calling station’s ID code is 123.• GROUP CALLSThis display appears when you are called with the groupcode, 888, and 888 has been programmed into code channelC6.• ERROR INFORMATIONWhen the transceiver receives an incomplete code, “E” andpreviously received code appear.■ Code squelchWhen using code squelch you will only receive calls from sta-tions which know your ID or group code. A 3-digit code is senteach time [PTT] is pushed in order to open the receiving sta-tion’s code squelch prior to voice transmission.q Set the operating frequency.• Set the volume and squelch to the desired level as in normal op-eration.w Push [A• FUNC ], then push [0• OPT].• Rotate [VOL] to select “dtm.CS,” if “dtm.PG” or “dtm.OF” ap-pears.e Select the desired transmit code channel:➥ Push and hold [0•OPT] for 1 sec. to enter code selectionmode.➥ Rotate [VOL] to select the desired code channel.➥ Push [✱•ENT ] to exit code selection mode and returnto previous mode.• 100 MHz digit shows “C.”r Operate the transceiver in the normal way (push [PTT] totransmit; release [PTT] to receive).t To cancel the code squelch, push [A• FUNC ] and [0• OPT ],then rotate [VOL] to select “dtm.OF.”• 100 MHz digit shows “1” for IC-V82 or “4” for IC-U82 when thefunction is cancelled.Previously received code.Code channel“CP” and “ ” blink.During channel number indication (described on page 16)To use these functions in channel number indication, thepager/code squelch setting must be programmed with othermemory contents before selecting channel number indication.