Icom iM323 Instruction Manual

Also see for IM323: Instruction manual

83 PREPARATIONThe 10 digit ATIS (Automatic Transmitter Identification Sys-tem) code can be programmed at power ON.This initial code setting can be performed only once.After being set, it can be changed by only your dealeror distributor. If your ATIS code has already been pro-grammed, this programming is not necessary.After programming the MMSI code, “Push [ENT] to Regis-qter Your ATIS” is displayed.Push [ENT] to start the ATIS code programming.w฀ •฀฀Push฀[CLEAR]฀twice฀to฀cancel฀the฀programming,฀and฀go฀to฀the฀normal operating mode. In this case, the ATIS function is dis-abled. To program the ATIS code, turn OFF the power, then turnit ON again.Enter your ATIS code in the following manner:e฀ •฀Select฀a฀desired฀number฀using฀Dial,฀or฀[∫]/[√]/[Ω]/[≈].฀ •฀Push฀[ENT]฀or฀Dial฀to฀set฀it.฀ •฀฀To฀move฀the฀cursor,฀select฀either฀arrow,฀“←” or “→,” then push[ENT] or Dial.Repeat stepr e to enter all 10 digits.After entering the 10 digit code, “FINISH” is automaticallytselected, and then push [ENT] or Dial to set it.The “ATIS CONFIRMATION” screen is displayed.yEnter your ATIS code again for confirmation.u฀ •฀Enter฀in฀the฀same฀manner฀as฀steps฀e through t.When your ATIS code programming is successfully com-ipleted, the screen as shown below is briefly displayed.฀ •฀After฀that,฀the฀normal฀operating฀screen฀is฀displayed.The programmed ATIS code can be checked in the MENUscreen. (p. 67)ATIS code programming■ (For Dutch and German version transceivers)