CWS-BA-e-0610249.4 Retrieving a stored reference weight via ID no.For storing a reference weight via an ID no. see chpt. 11.11. Turn on balance by pressing theON/OFF key. The three LEDs on thekeys "piece weight by" are flashing. Ifthis is this not the case, press thekey.2. Press key,“id-00“ appears with flashing „00“. a 0.000Kg Id 003. Enter ID no. via numeric keyboard (In-correct inputs can be deleted by press-ing the C key ).The ENTER key is flashing.a 0.000Kg Id 124. Confirm by pressing the key, thestored reference weight appears.Note:If no reference weight exists for the en-tered ID no. this will be indicated by anacoustic signal and the message "noid". The process will be reset to step 3.a 0.000Kg 12.0000g0Now you can place the parts to be counted onto the weighing plate.All piece number parameters of your load are displayed.Notes:• "id 00" is a special memory area. It always contains the most recently enteredreference weight.• A reference weight is stored automatically under "id 00" where it remains until anew reference weight is stored.• If a reference weight is deleted by pressing the key it can still be invokedvia "id 00".