CWS-BA-e-06103012.2 Automatic adding-upWhen the automatic summation function F-03-01 is enabled (for setting "1", see chpt.14.2.), the individual weighing values will be automatically added to the summationmemory without having to press the M+ after a rest position control was carried out.An acoustic signal indicates when all the weighing values have been added to thesummation memory.• Same procedure as for manual adding-up, see chpt. 12.1 but without pressingthe M+ key.• Please note that the balance must be unloaded between the individual weigh-ing procedures (display < +5d).• If function F-03-02 is set to "1" it is only possible to add positive counts (seechpt. 14.2.)12.3 Displaying a sum total1. Press the key and the total piecenumber as well as the number of weigh-ings will appear.Indicated by the [W ] display next to"TOTAL" and "N"2. Press the key again.The balance returns automatically intoweighing mode.Total number of piecesa12340.000Kg 7Number weighing processes12.4 Deleting all stored weighing data1. Keep pressing the key, press the key, then let go of both.2. This deletes the M+ memory.The [W ] display next to "M+" and „TOTAL“ disappears.Notes: Pressing the key will delete merely the display but not the data in the sum-mation memory. Data remains stored even after the balance was disconnected from the mains.12.5 M- function• The balance can subtract summation data from the M+ memory bypressing the key• For this purpose enable function F-09-01 in the menu (for setting "1",see chpt. 14.2).• This function is not used to delete the last M+ addition but to subtractthe summation data instead of adding. The sum total of the number ofweighings will be increased.• There is no automatic function M-.