6 DTMF24Stun allows an administrator to remotely disable astolen transceiver, using the DTMF function. Stun CodeThe Stun Code is a standby code of the Stunfunction.You can program the code (up to 10 digits) using 0~ 9, A ~ D, “*”, and “#”.The transceiver transponds when the Stun Codematches. TX InhibitThe transceiver cannot transmit. TX/RX InhibitThe transceiver cannot either transmit or receive(speaker unmute). In this status, the transceiverdoes not emit received signals even though thereceiver continues to operate.The transceiver stores the status even if thetransceiver is turned OFF.The TX Inhibit and TX/RX Inhibit status cannot bereset using the Auto Reset Timer function or anytransceiver operation. The transceiver status isreset only when the Stun Reset Code (Stun Code+ #) is received.The Stun status is reset when the transceiverreceives the Stun Reset Code (Stun Code + #)and transponds.6.3.10 Horn Alert LogicThis function allows you to change the Horn AlertLogic when receiving a DTMF ID Code that matchesthe code programmed in the transceiver. PulseThe Horn Alert Port toggles between Low andHigh every 500 ms, three times.500 ms 500 ms 500 ms 500 ms 500 ms ContinuousThe Horn Alert Port remains Low for the timeprogrammed in the Horn Alert Time. Horn Alert Time 6.3.11 Horn Alert TimeThe Horn Alert Time is the duration the Horn AlertPort remains Low after receiving a matching DTMFID Code.Default Until ResetRange Until Reset/ 1 ~ 30 s Until ResetThe Horn Alert Port remains Low when the DTMFID Code matches. It switches back to High whenthe code does not match.Note: You can use this function when the Horn Alert Logic isContinuous.6.3.12 DTMF Number DisplayThis function allows you to view the DTMF Codeupon receipt. The display is updated when thetransceiver does not receive another code for morethan 1 second after it receives the DTMF Code.Note: This function is available only when DTMF Signalling isOFF.6.3.13 Clear to TranspondThis function allows the transceiver to transpond afterthe Busy Signal on the current Channel is cleared.This function ensures the Transpond operation.The transceiver transponds immediately after theDTMF Code matches when this function is disabled.