Kenwood TK-7100H Service Manual

Also see for TK-7100H: Specifications Service manual

Contents

3211 Clone Mode11.1 OverviewThis mode is used for copying the tranceiver’sprogramming to another transceiver without using aPC.11.2 Function DescriptionYou must connect two transceivers using the CloneCable when cloning the programming information.One transceiver must be the Clone Master while theother is the Clone Slave. The Clone Master entersClone Mode and the Clone Slave enters normaloperation.11.2.1 Preparing for CloningConnect the Clone Master to the Clone Slave usingthe Clone Cable. The Clone Slave enters normaloperation. Press the [CH DOWN] key on the CloneMaster while turning it ON to enter the Clone Mode.“CLONE” appears on the display of the Clone Master.11.2.2 Starting the Cloning ProcessPress the [MON] key on the Clone Master to transmitthe programming data. “-PC- “ appears on the displayof the Clone Slave and it starts receiving the data.“End” appears on the display of the Clone Masterwhen transmission ends The Clone Slave transceiverautomatically activates with the new data. “ERROR”appears when the cloning process fails.11.2.3 Cloning AdditionalTransceivers“END” appears when the transceiver ends cloning.Press the [MON] key on the Clone Master transceiverto enter the Clone Mode again. Press the [MON] keyagain to transmit data. Repeat this operation to clonethe configuration data to several transceivers.11.2.4 Data Password“CLN LOCK” appears when the transceiver entersClone Mode and a Data Password has beenprogrammed. In this case, you cannot use thetransceiver as the Clone Master until it is unlocked.Enter the Data Password while “CLN LOCK” isdisplayed to unlock the transceiver. Press the [CHDOWN] key to confirm the Data Password. You canuse the transceiver as the Clone Master when it isunlocked.Note: You cannot enter the Clone Mode when the CloneMode is disabled.Note: The Clone Slave cannot receive the programming datawhen the Data Password is programmed in thetransceiver.Note: You cannot copy the programming data when themodel name and specification of the Clone Master andthe Clone Slave are different.