Keysight Technologies N3301A Programming Manual

Contents

Keysight Technologies N3301A Programming Manual Manual pdf 58 page image

4 - Language DictionaryCALibrate:PASSwordThis command can only be used in calibration mode. It allows you to change the calibration password.The new password is not saved until you send the CALibrate:SAVE command. If the password is set to 0,password protection is removed and the ability to enter the calibration mode is unrestricted.Command Syntax CALibrate:PASSword Parameters 0 (default)Examples CAL:PASS N3301A CAL:PASS 02.1997Related Commands CAL:STATCALibrate:SAVEThis command can only be used in calibration mode. It saves any new calibration constants (after acurrent or voltage calibration procedure has been completed) in nonvolatile memory.Command Syntax CALibrate:SAVEParameters NoneExamples CAL:SAVERelated Commands CAL:STATCALibrate:STATeThis command enables and disables calibration mode. The calibration mode must be enabled before theload will accept any other calibration commands. The first parameter specifies the enabled or disabledstate. The second parameter is the password. It is required if the calibration mode is being enabled andthe existing password is not 0. If the password is not entered or is incorrect, an error is generated and thecalibration mode remains disabled. The query statement returns only the state, not the password.Whenever the calibration state is changed from enabled to disabled, any new calibration constants arelost unless they have been stored with CALibrate:SAVE.Command Syntax CALibrate:STATe [,]Parameters 0 | 1 | OFF | ON [,]*RST Value OFFExamples CAL:STAT 1, N3301A CAL:STAT OFFQuery Syntax CALibrate:STATe?Returned Parameters Related Commands CAL:PASS CAL:SAVE58