Language Dictionary - 4[SOURce:]LIST:CURRent:RANGe[SOURce:]LIST:CURRent:RANGe:POINts?Channel SpecificThis command sets the current range for each list step. There are two current ranges.High Range: model dependent, see Table 4-1Low Range: model dependent, see Table 4-1When you program a range value, the load automatically selects the range that corresponds to the valuethat you program. If the value falls in a region where ranges overlap, the load selects the range with thehighest resolution. LIST:CURRent:RANGe:POINts? returns the number of points programmed.NOTE: If the existing IMMediate, TRANsient, and TRIGgered current list settings are outside thenew range, a list error is generated when the list is initiated and the list does not execute.Command Syntax [SOURce:]LIST:CURRent:RANGe {,}Parameters 0 through MAX | MINimum | MAXimumUnit A (amperes)*RST Value MAXimum (high range)Examples LIST:CURR:RANGE MINQuery Syntax [SOURce:]LIST:CURRent:RANGe?[SOURce:]LIST:CURRent:RANGe:POINts?Returned Parameters {,}Related Commands CURR:RANG[SOURce:]LIST:CURRent:SLEW[SOURce:]LIST:CURRent:SLEW:POINts?Channel SpecificThis command sets the current slew rate for each step. This command programs both positive andnegative going slew rates. MAXimum sets the slew to its fastest possible rate. MINimum sets the slew toits slowest rate. LIST:CURRent:SLEW:POINts? returns the number of points programmed.Command Syntax [SOURce:]LIST:CURRent:SLEW[:BOTH] {,}Parameters 0 to 9.9E37 | MAXimum | MINimumUnit A (amperes per second)*RST Value MAXimumExamples LIST:CURR:SLEW 50 LIST:CURR:SLEW MAXQuery Syntax [SOURce:]LIST:CURRent:SLEW[:BOTH]?[SOURce:]LIST:CURRent:SLEW:POINts?Returned Parameters {,}Related Commands CURR:SLEW79
