4 - Language DictionaryInput CommandsThese commands control the input of the electronic load. The INPut and OUTput commands areequivalent. The CURRent, RESistance and VOLTage commands program the actual input current,resistance, and voltage.[SOURce:]INPut[SOURce:]OUTPutChannel SpecificThese commands enable or disable the electronic load inputs. The state of a disabled input is a highimpedance condition.Command Syntax [SOURce:]INPut[:STATe] [SOURce:]OUTPut[:STATe] Parameters 0 | 1 | OFF | ON*RST Value ONExamples INP 1 OUTP:STAT ONQuery Syntax INPut[:STATe]?OUTPut[:STATe]?Returned Parameters 0 | 1Related Commands *RCL *SAV[SOURce:]INPut:PROTection:CLEar[SOURce:]OUTput:PROTection:CLEarChannel SpecificThese commands clear the latch that disables the input when a protection condition such as overvoltage(OV) or overcurrent (OC) is detected. All conditions that generated the fault must be removed before thelatch can be cleared. The input is then restored to the state it was in before the fault condition occurred.Command Syntax [SOURce:]INPut:PROTection:CLEar[SOURce:]OUTPut:PROTection:CLEarParameters NoneExamples OUTP:PROT:CLERelated Commands OUTP:PROT:DEL *SAV *RCL[SOURce:]INPut:SHORt[SOURce:]OUTPut:SHORtChannel SpecificThis command programs the specified electronic load module to the maximum current that it can sink inthe present operating range.Command Syntax [SOURce:]INPut:SHORt [SOURce:]OUTPut:SHORt Parameters 0 | 1 | OFF | ON*RST Value OFFExamples INP:SHOR 1 OUTP:SHOR ONQuery Syntax INPut:SHORt?Returned Parameters 0 | 1Related Commands INP OUTP60
